Often asked: How To Crochet A Hood On A Sweater?

How do you put a hood on a sweater?

Pin the center back hood to the center back of your shirt. Pin the tip of your hood to the front center or neck opening. Pin at the center point of that space (probably near the shoulder). Continue pinning by breaking your opening in half like this until you feel comfortable that your whole hood is secured.

How do you put a hood on a cardigan?

Lay your cardigan right side up and lay your hood right side down, centered, matching raw edges of the hood to the neckline. Pin in place. Sew along the hood using a 3/8 inch seam allowance.

How do you make a hood pattern?

How to Make a Hood By Tracing

  1. Take a hood you have from a garment in your cupboard.
  2. Fold your hood so the center seam is at the back and the front openings match.
  3. Lay it flat on a piece of paper and trace around the edge.
  4. Add seam allowance around your hood pattern.

How do you put a hood on a coat pattern?

If you are sewing an unlined jacket or shirt, you can line the hood easily by sewing a hood lining and sewing it right sides together with the main hood along the outside edge. Then turn the hood lining to the inside and sew the lining in place along the neckline. And just like that you have a hood.

You might be interested:  Quick Answer: How To Win The Ugly Sweater Contest?

How can I make my hoodie hood bigger?

Place the hoodie on the ironing board and iron it, starting at the top and stretching as you go. Be mindful not to stretch the armholes of the hoodie or the resulting fit will be awkward. When you’re near the bottom of the garment, stretch as much as you want or as far as the material will allow, and then iron it.

How do you crochet a flared collar?

Chain 1 and then work 2 single crochets in the first single crochet stitch. Single crochet in each stitch across, ending with 2 single crochets in the last stitch, turn. Work the extra stitch at both edges of the collar to add the flare to it. Repeat Steps 3 and 4 until the collar reaches 3 inches deep.

How do you crochet a ribbing at the beginning of a project?


  1. Figure out how wide you’d like your crochet ribbing to be and then work a starting chain of your desired length.
  2. Now fold your crochet ribbing in half and use slip stitches to join last and first row together.
  3. Turn your crochet ribbing inside out.

Leave a Reply

Your email address will not be published. Required fields are marked *